AI for Creo, starting with the model you have.

The initial Creo connector focuses on existing model workflows: inspecting parts and assemblies, updating parameters, regenerating models, and exporting results. These capabilities still need validation against a live Creo installation.

A useful evaluation starts with a model whose design intent is already captured. Name the parameter to change, describe the dependent geometry, and identify the checks that would make the revision acceptable.

• Inspect the current model before proposing changes.
• Use a bounded edit to an existing parameter or dimension.
• Check regeneration and measure the updated geometry.

The current connector approach does not create new sketch-based features from scratch. If your task needs a new sketch, extrude, or other newly authored feature, discuss that requirement before planning an evaluation.

The planned setup uses Creo Parametric on Windows with the VB API component installed. Your team supplies its own Creo license, and the required installation and automation setup must be checked for your environment.

Parameter changes can affect features and assembly references beyond the dimension you intended to edit. Review the regeneration state, affected interfaces, and resulting measurements in Creo.

Start with a copy and agree on saving and export behavior. A successful export is one checkpoint; the native model's editability and engineering acceptance need their own review.